This is a neck peg that raises the Tamashii Nation’s S.H. Figuarts head 3mm higher so he will look more proportionate.
Two sizes available. One for the stock cape, and one for aftermarket fluffier capes (check picture of Full Beskar)
Currently no pictures of 2mm.
Works with both Pre-Beskar and Full Beskar Armored versions.
- This is a 3D printed FDM part in made with PETG. This is printed laying down for the strongest print possible. Therefore the underside may be unaesthetic or for lack of a better term, "ugly". This is usually normal for most FDM prints and will not prevent or hinder articulation. Just make sure the peg can sit in the holes. Some light sanding may be needed but for the most part it will snap fit in. This is also stronger than Resin or PLA so no need to worry about breaking the peg inside your expensive action figure.
- Tolerances are tight just like the factory one. You may need to use pliers to insert it but be aware that Addictedcollectibles.com is not responsible for any damages caused by the disassembly of the factory parts and reassembly of the aftermarket parts.
- Be mindful that this is a 3D printed part, repeated removal may loosen/damage parts.
- This product has a 30 day warranty from date of ship.
Products may contain sharp points, small parts, choking hazards, and other elements not suitable for children under 16 years old.